|
10-27-snyatie-i-ustanovka-rulevogo-kolesa.html
10.27. Removal and installation of a steering wheel
|
|
Cars considered in the real Management are equipped with system of additional safety of SRS which is better known as a safety cushion. Before performing any works near assembly of a pillow or a steering column, without fail disconnect system in order to avoid receiving traumas as a result of its casual operation (see. Head Electric equipment). Isolation and contact sockets of electroconducting of a chain of SRS are painted in bright yellow color. It is not necessary to connect any diagnostic devices to this chain! |
Removal
|
|
Bolts of fastening of the module of a safety cushion are planted on special hermetic and to a reuse are not subject. |
|
|
- Before starting removal of a steering wheel, деактивируйте SRS (see. Head Electric equipment).
- Remove the bottom cover of a casing of a steering column.
- Disconnect electroconducting from the module of a driver's face-to-face safety cushion, then remove the left and right sections of a casing.
|
- By means of a key of the TORX type turn out bolts of fastening of the module (see the prevention).
|
|
- Remove a safety cushion and a spiral cable drum. Transfer assembly on a workbench and lay it a slip up.
- Bring forward wheels of the car into rectilinear situation.
- Disconnect horn electroconducting, and also all other electroconducting disturbing to removal of a steering wheel.
- Give a nut of fastening of a steering wheel, remove a washer and mark the provision of a wheel concerning a shaft of a steering column.
|
- By means of a special stripper remove a steering wheel and disconnect a cable of a drive of blocking of switching of AT.
|
|
|
|
|
Do not draw a stripper bolt! Do not make attempts of knocking down of a steering wheel by means of a hammer! |
Installation
|
|
- Make sure that forward wheels still are in rectilinear situation.
- Check correctness of combination of a uvula of the sensor switch of the returnable device of the switch of indexes of turn with reciprocal risky the podrulevy switch.
|
- Make sure that the spiral cable SRS reel is in neutral (central) situation, and adjusting labels correctly are combined.
|
|
|
|
At the wrong installation the cable drum can appear jammed at strong deployment of a steering wheel! |
|
- Establish a drum on a steering column. In case of need make drum centering for what turn it on 2.5 turns from extreme situation and achieve combination of adjusting labels. For reliability temporarily fix a drum in neutral situation by means of an adhesive tape.
|
|
- Connect to a cable drum electroconducting.
- Connect a cable of blocking of switching of AT.
- Establish a casing of a steering column and remove fixing cable drum an adhesive tape.
- Establish a steering wheel — track correctness of hit of a directing pin of a cable drum in reciprocal nests.
- Pass a cable drum in a wheel nave.
- Connect horn electroconducting, then enter a cable drum into gearing with ratchet doggies of a steering wheel.
- Tighten with demanded effort a nut of fastening of a steering wheel.
- Establish into place the safety cushion module, screw NEW fixing bolts and tighten them with demanded effort.
- Establish into place remained elements of a casing of a steering column.
- In summary make SRS activation (see. Head Electric equipment).
|
|
|
|
