Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
12.1. Specifications
12.2. Search of causes of failures of electric equipment
12.3. Electric sockets - general information
12.4. Safety locks and fusible inserts - the general information
12.5. Chain breakers - the general information
12.6. The relay - the general information and check of serviceability of functioning
12.7. Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
12.8. Replacement of lamps of lighting devices
12.9. Check of serviceability of functioning and regenerative repair of a heater of back glass
12.10. System of additional safety (SRS)
12.11. Schemes of electric connections
 








8099f600






12-5-preryvateli-cepi-obshhaya-informaciya.html

12.5. Chain breakers - the general information


Arrangement of two breakers of a chain in salon the assembly block of safety locks / relay

Breakers of a chain are used for protection of such components of system of onboard electric equipment, as head headlights and electromotors of a drive of window regulators / cover of the top hatch / door locks, etc. (see an illustration above).

On some models after operation breakers revert to the original state automatically. If causing breaker shutdown the overload had not incidental character, it is necessary to check a condition of the corresponding contour immediately. After malfunction elimination the chain breaker enters again into a normal mode of functioning. Sometimes return of the breaker to a working condition should be made manually after elimination of the reason of an overload.

For breaker introduction in a working condition disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for audiosystem input in action!

Take the breaker, pass a thin core in specially provided opening in the case and push it in an opening before click. Then it is meaningful to make sure by means of an ohmmeter available conductivity between plugs of the breaker and after it to establish it into place.


«on page back
12.4. Safety locks and fusible inserts - the general information
on the following page»
12.6. The relay - the general information and check of serviceability of functioning