Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
9. Brake system
10. Suspension bracket and steering
11. Body
11.1. Wash of the car
11.2. Care of body elements and paint and varnish covering
11.3. Care of vinyl elements of furnish
11.4. Care of the chromeplated elements of furnish
11.5. Care of cast aluminum disks
11.6. Care of upholstery elements, carpets of salon and seat belts
11.7. Repair of insignificant damages of body panels
11.8. Repair of seriously damaged body panels
11.9. Service of loops and car locks
12. Electric equipment
 








8099f600 Операционный офтальмологический






11-1-mojjka-avtomobilya.html

11.1. Wash of the car

In the cases listed below it is necessary to subject the car immediately to drive away on a sink:

  • After hit under a rain which can quite contain acid in a modern ecological situation;
  • After a trip in coastal areas;
  • At hit on a paint and varnish covering of soot, a bird's dung, wood pitch, remains of insects and a metal dust;
  • At emergence of a road film.

Whenever possible try to keep the car in covered garage.

At a parking on the street try, that the car whenever possible remained in the shadow.

When drawing sheetings try not to allow LKP damages!

At performance of a wash of the car by own forces first of all, as far as possible, it is necessary to bring down the stuck dirt and a dust layer a water stream under pressure, then with a damp sponge carefully to remove the remains of pollution. For a fair sink use patent cleaners, or weak solution of soap in warm (is not hotter!) to water. In summary rinse a body surface with plentiful quantity at its finest.

Do not forget to wash away also dirt from the bottom of the car and internal surfaces of wheel arches.

Having finished a sink, carefully wipe the painted body elements pure soft rags, having completely removed from them moisture traces.

In отгибах flanges, cavities of seams, folds of body panels, loops of doors and a cowl, etc. places always accumulate containing applied to paving processing adjournment salt in view of what they should be cleaned regularly carefully. Watch, that passableness of drainage openings in bottom edges of door assemblies was not broken.


«on page back
11. Body
on the following page»
11.2. Care of body elements and paint and varnish covering