Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement of blocks of disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (GTTs)
9.9. Removal and installation of assembly of the vacuum amplifier of brakes
9.10. Pumping of brake system
9.11. Adjustment of a drive of the parking brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve regulator (LSV) sensitive to loading
9.14. Adjustment of sensors switches of stoplights and темпостата
9.15. Removal and ABS hydromodulator installation
9.16. Removal and G-sensor installation
9.17. Check of serviceability of functioning of wheel ABS sensors
9.18. Check of serviceability of functioning of the G-sensor
9.19. Check of serviceability of functioning of the relay of the driving electromotor of the hydromodulator
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator
10. Suspension bracket and steering
11. Body
12. Electric equipment
 








8099f600






9-15-snyatie-i-ustanovka-gidromodulyatora-abs.html

9.15. Removal and ABS hydromodulator installation

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Merge hydraulic liquid from brake lines.
  3. Mark adjusting position of lines and disconnect them from hydromodulator assembly (see an illustration the arrangement Scheme on the car of the elements ABS).
  4. Disconnect from the modulator electroconducting.
  5. Give three fixing nuts and remove hydromodulator assembly.
  6. Without tightening shtutserny sockets connect to the modulator hydraulic lines.
  7. Establish modulator assembly on the regular place and tighten fixing nuts.
  8. Tighten with demanded effort shtutserny sockets of brake lines.
  9. In summary add in the GTTs tank necessary amount of hydraulic liquid of a demanded grade and pump over brake system (see. Pumping of brake system).


«on page back
9.14. Adjustment of sensors switches of stoplights and темпостата
on the following page»
9.16. Removal and G-sensor installation