Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement of blocks of disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (GTTs)
9.9. Removal and installation of assembly of the vacuum amplifier of brakes
9.10. Pumping of brake system
9.11. Adjustment of a drive of the parking brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve regulator (LSV) sensitive to loading
9.14. Adjustment of sensors switches of stoplights and темпостата
9.15. Removal and ABS hydromodulator installation
9.16. Removal and G-sensor installation
9.17. Check of serviceability of functioning of wheel ABS sensors
9.18. Check of serviceability of functioning of the G-sensor
9.19. Check of serviceability of functioning of the relay of the driving electromotor of the hydromodulator
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator
10. Suspension bracket and steering
11. Body
12. Electric equipment
 








8099f600






9-6-snyatie-i-ustanovka-tormoznogo-diska.html

9.6. Removal and installation of a brake disk

 PERFORMANCE ORDER

  1. To Poddomkratta the car also establish it on props (see an illustration the Scheme of an institution of props for car fixing in the lifted situation). Remove the corresponding forward wheel.
  2. Remove a support of the brake mechanism (see. Removal and installation of a support of the disk brake mechanism), without disconnecting from it the hydraulic line. Tie up a support a wire to suspension bracket elements — try not to allow tension of a brake hose.
  3. Uncover a stupichny nut.
  4. Give a bearing nut, remove a lock ring, a shpindelny, persistent and lock washer, unscrew a stupichny nut remove a nave assembled with a brake disk.
  5. In case of need separate a disk from a nave.
  6. Installation is made upside-down.


«on page back
9.5. Removal and installation of a support of the disk brake mechanism
on the following page»
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels