Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
8.1. 4-step automatic transmission
8.2. Transfer case
8.2.1. General information
8.2.2. Removal and installation of a transfer case
8.2.3. Removal and installation of the driving electromotor of the actuation mechanism of a transfer case
8.2.4. Replacement of the oil filter of a transfer case
8.2.5. Replacement of epiploons of a target shaft of a transfer case
8.2.6. Replacement of an epiploon of a rod of switching of a transfer case
8.3. Differentials, power shafts / semi-axis
8.4. Driveshafts
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
 








8099f600






8-2-razdatochnaya-korobka.html

8.2. Transfer case

The transfer case is established behind the power unit. The engine torque through transmission and a transfer case is transferred on lobbies and back driving shaft/semi-axes by means of driveshafts.

On a design and an action principle the transfer case used on the Infiniti QX4 models belongs to polnorezhimny (All-mode) with electronic and hydraulic management — see below-mentioned illustrations:

As the think-tank the module of management of automatic transmission (TCM) acts. Refusals of 4WD system are fixed in memory of the module of management and can be считаны by means of the CONSULT type scanner, or on signals of a control lamp. Problem diagnostics of AT and 4WD system should be made in the conditions of a car-care center workshop.

Originators of the real Management do not recommend to motorists to make in house conditions of attempt of independent performance of regenerative repair of the failed transfer case. Work demands existence of special tools and a certain qualification of the performer. Nevertheless, independent performance of procedures of removal and installation of the transfer case, which description is given further, will allow in an essential measure to cut down the expenses connected both with repair, and with replacement of the failed assembly.


Schematic diagram of functioning of control system AT/4WD


Base principles of functioning of a transfer case


Function chart of a hydraulic contour of management of 4WD system


Function chart of a control system of 4WD


«on page back
8.1.11. Major maintenance of AT
on the following page»
8.2.1. General information