Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
8.1. 4-step automatic transmission
8.1.1. General information
8.1.2. AT problem diagnostics - the general information
8.1.3. Electronic and hydraulic control system of 4-step AT
8.1.4. Removal and transmission installation
8.1.5. Replacement of an epiploon of lengthening of transmission
8.1.6. Removal and installation of a cooler of ATF
8.1.7. Removal and installation of klapanny assembly of a hydraulic contour of management of AT
8.1.8. Removal, check of a condition and installation of a driving cable of blocking of switchings
8.1.9. Adjustment of a drive of switching of AT
8.1.10. Adjustment of the sensor switch of provisions of AT / permission of start
8.1.11. Major maintenance of AT
8.2. Transfer case
8.3. Differentials, power shafts / semi-axis
8.4. Driveshafts
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
 








8099f600






8-1-6-snyatie-i-ustanovka-okhladitelya-atf.html

8.1.6. Removal and installation of a cooler of ATF


Details of installation of a cooler of ATF


Scheme of connection of lines of a path of cooling of ATF

 PERFORMANCE ORDER

  1. Remove a decorative front grille.
  2. Disconnect from assembly of a cooler of ATF hoses.
  3. Release fixture and remove cooler assembly.
  4. Remove a basic arm of a cooler of ATF.
  5. Release fixing collars and remove the hoses going from a cooler to a radiator and to transmission (see an illustration the Scheme of connection of lines of a path of cooling of ATF).
  6. Turn out bolts of fastening of a basic arm of a tube of a cooler.
  7. Remove a hose assembled with a basic arm.
  8. Installation is made upside-down — track, that all fixture was tightened a support with demanded effort.
  9. In summary check ATF level, in case of need make the corresponding adjustment (see. Head Routine maintenance).


«on page back
8.1.5. Replacement of an epiploon of lengthening of transmission
on the following page»
8.1.7. Removal and installation of klapanny assembly of a hydraulic contour of management of AT