Removal and installation of klapanny assembly of a hydraulic contour of management of AT. Infiniti QX4 (since 1996 of release)
8099f600
Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
8.1. 4-step automatic transmission
8.1.1. General information
8.1.2. AT problem diagnostics - the general information
8.1.3. Electronic and hydraulic control system of 4-step AT
8.1.4. Removal and transmission installation
8.1.5. Replacement of an epiploon of lengthening of transmission
8.1.6. Removal and installation of a cooler of ATF
8.1.7. Removal and installation of klapanny assembly of a hydraulic contour of management of AT
8.1.8. Removal, check of a condition and installation of a driving cable of blocking of switchings
8.1.9. Adjustment of a drive of switching of AT
8.1.10. Adjustment of the sensor switch of provisions of AT / permission of start
8.1.11. Major maintenance of AT
8.2. Transfer case
8.3. Differentials, power shafts / semi-axis
8.4. Driveshafts
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
 






8099f600





8-1-7-snyatie-i-ustanovka-klapannojj-sborki-gidravlicheskogo-kontura-upravleniya-at.html

8.1.7. Removal and installation of klapanny assembly of a hydraulic contour of management of AT

The detailed description of a design, principle of functioning and procedures of service and major maintenance of klapanny assembly is provided in the Guide to automatic transmissions of an ARUS No. 179 series (ISBN 5-89744-069-7).

Details of fastening of klapanny assembly of management of AT

Length of bolts, mm:

And — 33
In — 45


 PERFORMANCE ORDER

  1. Remove forward section of system of production of the fulfilled gases.
  1. Remove the case pallet with sealing laying and merge ATF.
  1. In case of need remove the sensor of temperature of ATF.
  1. Remove the mesh filter.
  2. Disconnect electroconducting, turn out fixing bolts (try to remember the adjusting provision of bolts) and remove klapanny assembly (see an illustration of the Detail of fastening of klapanny assembly of management of AT).
  1. In case of need make replacement of the failed internal components of klapanny assembly, for extraction of accumulators A, B, C and D use the compressed air.
  1. Assembly and installation are made as it should be, the return to an order of dismantle of components — do not forget to replace all sealing elements, track, that all fixture was tightened with demanded effort.


«on page back
8.1.6. Removal and installation of a cooler of ATF
on the following page»
8.1.8. Removal, check of a condition and installation of a driving cable of blocking of switchings