Infiniti QX4 service since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
4.1. Specifications
4.2. Check of kompressionny pressure in cylinders
4.3. Diagnostics of a condition of the engine with use of the vacuum gage
4.4. Removal and engine installation
4.5. Removal and installation of the inlet pipeline
4.6. Replacement of a belt of a drive of GRM
4.7. Removal, check of a condition and installation of a head of cylinders
4.8. Replacement of a forward epiploon of a cranked shaft
4.9. Removal, check of a condition and installation of components of the klapanny mechanism
4.10. Replacement of epiploons of camshafts
4.11. Replacement of a back epiploon of a cranked shaft
4.12. Removal and installation of the pallet of a case
4.13. Removal, service and installation of the oil pump
4.14. Alternative versions of schemes of regenerative repair of the engine
4.15. An order of dismantling of the engine by its preparation for major maintenance
4.16. Dismantling and check of a condition of a head of cylinders and components of the klapanny mechanism
4.17. Recommendations about service of valves
4.18. Assembly of a head of cylinders
4.19. Removal of shatunno-piston assemblies
4.20. Removal of a cranked shaft
4.21. Cleaning of the block of the engine
4.22. Check of a condition of the block of the engine
4.23. Honingovaniye of mirrors of cylinders
4.24. Check of a condition of components of shatunno-piston group
4.25. Check of a condition of a cranked shaft
4.26. Check of a condition and selection of loose leaves of radical and shatunny bearings of a cranked shaft
4.27. Engine assembly order
4.28. Installation of piston rings
4.29. Installation of a cranked shaft and check of working gaps of radical bearings
4.30. Installation of shatunno-piston assemblies and check of size of working gaps in shatunny bearings of a cranked shaft
4.31. Trial start and an engine running in after major maintenance
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. Transmission line
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
 












4-8-zamena-perednego-salnika-kolenchatogo-vala.html

4.8. Replacement of a forward epiploon of a cranked shaft

The forward epiploon of a cranked shaft is planted in the case of the oil pump, originators of the real Management recommend to remove the pump previously.


Removal

 PERFORMANCE ORDER

  1. Remove the oil pump (see. Removal, service and installation of the oil pump).
  1. Having hooked the suitable tool, take an old epiploon from the landing nest in the pump case. Act carefully Ч try not to damage sealing walls of a nest. Try to remember adjusting полоежине an epiploon.


Installation

 PERFORMANCE ORDER

  1. Grease sealing sponges of a new epiploon with pure impellent oil.
 
  1. Fill an epiploon in a reception nest and by means of a suitable opravka press it aflush with an external surface of the case of the pump.

As an opravka the replaceable face head of the corresponding size, or a piece of a pipe of suitable diameter can be used, the opravka should rest only against a rigid face surface of an epiploon!

  1. Further installation is made as it should be, the return to an order of dismantle of components Ч track, that all fixture was tightened with demanded effort.


Ђon page back
4.7. Removal, check of a condition and installation of a head of cylinders
on the following pageї
4.9. Removal, check of a condition and installation of components of the klapanny mechanism